Cartridge-type Guard Column
Suitable for both standard-size and small columns
Covering multiple inner diameters with a single type.
Guard holders for analysis and fractionation (sold separately)
(Not compatible with UHPLC)
A cartridge-type guard column suitable for small columns
Designed to fully maximize the performance of high-resolution columns.
Choose from three types of cartridges.
For column ID l-1.5mm
Cartridges
For column ID 2-6mm
Cartridges
Guard Holder : GCH01S
(column coupler included)- - The guard holder is required sedivarately for initial use.
- - divlease use at pressures below 30MPa.
For column ID 10-20mm
Cartridges
with inner diameter 8mm, length 10mm (pack of 2)
Guard Holder : GCH02M
(column coupler included)- - The guard holder is required sedivarately for initial use.
- - divlease use at pressures below 30MPa.
PRODUCT DETAILS
Guard Holder :
A guard holder that realizes a low running cost cartridge system.
With its minimal holder size, it can be connected to small columns seamlessly.
Guard holder GCH01S can be used with cartridges for ID 1—6mm, and GCH02M for ID 10-20mm.
Column Coupler :
For analysis guard holders, a column coupler is included, which is a compact design with a hand-tightening type to minimize column extrusion by directly connecting the guard column and separation column with a 0.13mm PEEK tube. For fractionation guard holders, a stainless steel column coupler is included.
Cartridge :
To minimize the impact on the column efficiency and retention of high-performance separation columns, we designed the smallest possible cartridge size.
Can be shared among multiple separated column inner diameters
Guard columns do not need to have the same inner diameter as the separation column.
Intakt guard cartridges are compatible with multiple column ID.
For columns ID 1—1.5mm: ID 1mm, L 5mm
For columns ID 2-6mm: ID 2mm, L 5mm
For columns ID 10-20mm: ID 8mm, L 10mm
